How to Securely Attach a Basketball to the Shooting Correction Machine
This guide explains how to properly attach a basketball to the Shooting Correction Machine using epoxy adhesive.
Following these steps carefully will ensure a strong, durable, and safe connection.
Important Information
- A basketball is included as a gift with your purchase
- Any standard basketball can be used on the machine
- You may also attach your own basketball
- Proper attachment is essential for safe and effective training
⚠️ Do not use the machine until the adhesive has fully cured.
Materials Needed
- Two-part epoxy adhesive
- Mixing container
- Stirring stick
- Protective gloves
- Clean cloth
- Sandpaper (optional)
Step 1: Surface Preparation
- Make sure the basketball surface and the machine arm are clean and dry
- Remove dust, oil, or moisture using a clean cloth
- If the surface is very smooth, lightly sand it to improve adhesion
Proper surface preparation is critical for a strong bond.
Step 2: Mixing the Epoxy Adhesive
- Use a two-part epoxy adhesive
- If no instructions are provided, mix at a 1:1 ratio (equal parts resin and hardener)
- Stir thoroughly until the mixture has a uniform consistency
⚠️ Do not rush this step. Poor mixing weakens the bond.
Step 3: Application & Bonding
- Apply an even layer of epoxy to:
- The basketball contact area
- The machine arm ball mount
- Carefully position the basketball onto the arm
- Press firmly to ensure full contact
Wipe away any excess epoxy before it hardens.
Step 4: Curing Process
- Hold the basketball in place briefly to prevent movement
- Allow the adhesive to cure for at least 24 hours
- For maximum strength, allow up to 48 hours of curing time
✅ Ideal curing temperature: 68–77°F (20–25°C)
❌ Do not move or use the machine during curing
Final Check Before Use
Before training:
- Confirm the basketball is firmly attached
- Gently test for movement — there should be none
- Ensure the ball rotates smoothly
If the ball feels loose, do not use the machine and repeat the process.
Helpful Tips
- Always wear gloves when handling epoxy
- Avoid over-applying adhesive
- Never rush the curing process
- Do not expose the bond to extreme heat or cold while curing
Need Assistance?
If you experience any issues attaching the basketball or have questions:
- Visit our Support section
- Or contact our team directly
At HoopsBasket, we are committed to helping you get the best performance from your Shooting Correction Machine.